User Manual

Hyperlink Extended Range WLAN Kit Installation Manual Rev. A Page
15
Hyperlink Technologies, Inc.
10. The DC Power Injector and Power Supply must be installed indoors near the
radio. The Injector unit can be wall-mounted using the included bracket if
desired. Attach the end of the 50 ft. antenna cable to the “TO AMPLIFIER”
connector on the DC Power Injector/Lightning Protector. Attach the 0.5 meter
adapter cable between the DC Power Injector’s “TO RADIO” connector and the
WaveLAN card.
11. Attach a ground wire to the ground lug on the DC Power Injector/Lightning
Protector and to a good building ground.
12. First, plug the 12 VDC power supply into the DC Power injector and then into
the building’s AC power. Never use a power supply other than the one shipped
with the system as it may cause damage to the radio and/or amplifier. It is
further recommended that the AC connections be made through a commercially
available "surge" protector power strip.