User Manual

Press the center soft key EDIT.
Press the up/down keys to enable (ENA) or disabled (dSA)
Zone 1 Temperature Sensor 1. See Fig. 29. Make the
same selections for sensors 2 through 4 for Zone 1.
FIG. 29
Once all have been selected for Zone 1, Temperature
Sensor 1 through 4, , press the right soft key NEXT to
access Zone 2, Temperature Sensor 1. Enable the sensor
using the up/down keys. When completed, press the left
soft key DONE.
To continue set-up, press right soft key NEXT. The following
screen is displayed.
C
CALIBRATING TEMPERATURE SENSORS
This selection allows correlation between the room
controller’s sensors and the SmartBoxsensors.
FIG. 30
Press the center soft key EDIT. The following screen is
displayed.
FIG. 31
-- Before making any adjustments, you must allow the
temperature between the room controller sensors
and the SmartBox
sensors to stabilize.
-- Once temperatures have stabilized, use the up/down
keys to enter room temperature sensor offset.
Press the right soft key NEXT to set temperature offset for
Zone 1, Temperature Sensors 1 through 4. Complete
the same process for Zone 2, Temperature Sensor 1.
Use the up/down keys accordingly.
-- Example: If the room controller reads 70 F and the
SmartBox
reads 69 F, set the offset temperature 1F
by pressing the up key.
Press the leftsoft key DONE, then press NEXT. The
following screen is displayed
FIG. 32
Press the center soft key EDIT to view the heat load
percent in Zone 1. See Fig. 33. To view Zone 2, press right
center soft key NEXT
FIG. 33
Press the up/down keys and center soft key
simultaneously to exit the set-up mode and to return you
back to the Home Screen. Now determine your
temperature curve.
12