User's Manual

Chapter 3 – Operating Instructions
SKY899 Pilot’s Guide
3-4
Preliminary
The SKY899 switches
out of standby into
the above display
mode and
6 nmi
range (figure
3-6).
If your aircraft has a
squat switch and you
don’t manually switch
out of standby, the
SKY899 automatically
switches out of
standby
8 to 10
seconds after takeoff.
2. To manually switch
into standby from the traffic screen, press the button
labeled
>>
>>
>
STB .
The SKY899 goes into standby and the display switches back
to the standby screen. (If your aircraft has a squat switch, the
>
STB
button label is not displayed while airborne, and the
SKY899 will not go into standby while airborne.)
If your aircraft has a squat switch, the
SKY899 also goes into
standby automatically,
24 seconds after landing. This delay
allows the
SKY899 to remain out of standby during a touch-
and-go maneuver.
Change the Display Range
You can change the display range when the SKY899 is in normal
operating mode.
1. Press the display range button to toggle the display range
between
15 , 6 , and 2 nmi (figure 3-7 ).
15
nm
6
nm
2
nm
6 nmi 2 nmi
15 nmi 6 nmi 2 nmi
Figure 3-7. Display Ranges
Change the Display Range
Figure 3-6.Traffic Screen on the
Ground
BRT
OFF
ABV
6
nm
+94
+10
+04
STB