User Guide Part 2
Table Of Contents
- Chapter 2 Operating Instructions
- Controls & Indicators
- Turn On the SKY497
- Run the Operator-Initiated Self Test
- Switch Between Standby and Normal Operating Mode
- Change the Display Range
- Change the Altitude Display Mode
- Switch Between SKYWATCH and STORMSCOPE Modes (Optional)
- Observe the Display
- Respond to Traffic Advisories
- Turn Off the SKY497 and the Optional WX-1000
- Failure Response
- Operate the Optional WX-1000 When the SKY497 is Removed
- Operate the SKY497 When the Optional WX-1000 is Removed
- Chapter 3 Principles of Operation
- Chapter 4 Display Interpretation
- Chapter 5 Specifications
- Chapter 6 Warranty Information
- Record of Important Information
- Back Cover
Pilot’s Guide 2-5
SKY497
Operating Instructions
OPRTEST
Standby
SKY497
BRT
OFF
BFGoodrichAvionicsSystems,Inc.
BRT
OFF
Figure 2-2. BFGoodrich Screen Figure 2-3. SKY497 Standby Screen
TEST
Failed
SKY497
Error
ProcessorComm.
145
BRT
OFF
NRM
6
nm
-13
+01
+25
+10
+05
BRT
OFF
Figure 2-4. In-Flight Traffic Screen Figure 2-5. SKY497 Failed Screen
2.If you hear “Traffic Advisory Sys-
tem Test Failed” or see a
SKY497
Failed screen (figure 2-5), push
the test button again. If it contin-
ues to fail, refer to the Failure
Response section on page 2-9.
3.If you hear “Traffic Advisory Sys-
tem Test Passed” without seeing
the test screen, turn off the
SKY497
using the
OFF/BRT
knob
and contact your authorized
BFGoodrich Avionics Systems
dealer for troubleshooting help.
6
nm
NRM
SYSTEM
TEST
IN
PROGRE
S
S
-10
+10
-02
BRT
OFF
Figure 2-6. Operator-Initiated Test Screen