User Guide Part 2
Table Of Contents
- Chapter 2 Operating Instructions
- Controls & Indicators
- Turn On the SKY497
- Run the Operator-Initiated Self Test
- Switch Between Standby and Normal Operating Mode
- Change the Display Range
- Change the Altitude Display Mode
- Switch Between SKYWATCH and STORMSCOPE Modes (Optional)
- Observe the Display
- Respond to Traffic Advisories
- Turn Off the SKY497 and the Optional WX-1000
- Failure Response
- Operate the Optional WX-1000 When the SKY497 is Removed
- Operate the SKY497 When the Optional WX-1000 is Removed
- Chapter 3 Principles of Operation
- Chapter 4 Display Interpretation
- Chapter 5 Specifications
- Chapter 6 Warranty Information
- Record of Important Information
- Back Cover
2-10 Pilot’s Guide
Operating Instructions
SKY497
4. Remove power from the
SKY497
at the circuit breaker.
If you haven’t already manually switched into
STORMSCOPE
mode, the display will
automatically switch into
STORMSCOPE
mode once you disconnect power from the
SKY497
regardless of the position of the
SKYWATCH/STORMSCOPE
mode switch.
5. Contact your authorized BFGoodrich Avionics Systems dealer for trouble-
shooting help. Be sure to give the troubleshooting personnel the error
number and description that you wrote down in step 2.
Operate the Optional WX-1000 When the SKY497 is Removed
After removing the
SKY497
for maintenance, maintenance personnel will install a jumper
plug that will allow continued operation of the
WX-1000
.
Operate the SKY497 When the Optional WX-1000 is Removed
After removing the
WX-1000
for maintenance, maintenance personnel will move the
WX-
1000
maintenance switch to the
OVERRIDE
(
WX-1000
maintenance) position to allow
continued operation of the
SKY497
.