Install Manual Part 3

SKY497
Installation Manual
D-5
Rev. C
Commands Descriptions
Help or ?
The help or ? command displays a list of available commands. Executing the
Help command displays the following list.
stp>?
? .................... Command help
Arinc429 ............. Arinc 429 cmds
Arinc735 ............. Arinc 735 cmds
Bar .................. Displays barometric altitude
Cal .................. Executes antenna calibration
Config ............... SKY497 Config Options
Dump ................. Displays the List of Logged Errors
Ground ............... Turns ground test mode on or off
Head ................. Displays heading
Help ................. Command help
Rad .................. Displays Radio altitude
Save ................. Saves System Configuration
Say .................. Says Phrase from Speech Chip
Sensors .............. Displays sensor data
Version .............. SW Version information
For Information on any particular command, enter the command followed
by help.
Save
Saves all configuration jumper settings into system memory. Once the data
is written to memory the saved configuration data is displayed on the
terminal device. The system configuration is read on power up and compared
to the current jumpers. If the jumpers disagree with the saved memory, an
Error 30 will occur. Configuration jumpers can also be read by typing the
Config command.
stp>save
Saving SKY497 Config Straps:
Configuration P1-70, Heading. set to Ground.
Configuration P1-69, Heading. set to Open.
Configuration P1-68, HeadFlgSen set to High.
Configuration P1-67, DR/Alt.422 set to Data Rec.
Configuration P1-100, Ant.Pos. set to Top.
Configuration P1-99, Ant.Type set to NY-164.
Configuration P1-98, Airframe set to Fixed Wing.
Configuration P1-80, AltDispType set to Open.
Configuration P1-79, AltDispType set to Open.
Configuration P1-78, AltDispType set to Open.
Configuration P1-77, AltDispType set to Open.
Say (help | 1-4)
Forces the TRC to announce one of four commands, depending on the
number (1 thru 4) entered after the command SAY. Can be used to help
troubleshoot audio output problems.
say help: Displays command specific help message.
say 1: Traffic Avoidance System Test
say 2: Passed
say 3: Failed
say 4: Traffic! Traffic!