Setup guide

Panel Setup
12 SETUP GUIDE
IMPORTANT: Check with your network administrator when selecting the network
setting. After all network related settings have been done, turn the machine Off and
On again.
TCP/IP (Enable/Disable TCP/IP)
This selects the settings for TCP/IP.
1
Press [System Menu/Counter]. The Sys. Menu/Count. screen appears.
2
Press U or V to select System.
3
Enter the user ID and password to log in.
NOTE: The default settings of user ID and password are both 2800.
4
Press [OK]. The System screen appears.
5
Press U or V to select Network Setting.
6
Press [OK]. The Network Setting screen appears.
7
Press U or V to select TCP/IP Setting.
8
Press [OK]. The TCP/IP Setting screen appears.
9
Press U or V to select TCP/IP.
10
Press [OK]. The TCP/IP screen appears.
11
Press U or V to select whether TCP/IP is enabled.
12
Press [OK]. The TCP/IP is set and the TCP/IP Setting menu reappears.
IPv4 Settings (TCP/IP IPv4 settings)
This selects the settings for TCP/IP (IPv4).
1
In the TCP/IP Setting menu, press U or V to select IPv4 Setting.
2
Press [OK]. The IPv4 Setting menu screen appears.
The options available in the TCP/IP (IPv4) settings are as follows:
• DHCP (DHCP setting)
• Bonjour (Bonjour setting)
• IP Address (IP address setting)
• Subnet Mask (Subnet mask setting)
• Default Gateway (Gateway setting)