Specifications

2-17
Installing and Setting up the Machine > Default Settings of the Machine
6 Press the [▲] or [▼] key to select [Subnet Mask], and press the [OK] key.
7 Use the numeric keys or press the [▲] or [▼] key to set the subnet mask.
You can set any value between 000 and 255. The entry method is the same method as the IP
address.
8 Press the [OK] key.
9 Press the [▲] or [▼] key to select [Default Gateway], and press the [OK] key.
10 Use the numeric keys or press the [▲] or [▼] key to set the default gateway.
You can set any value between 000 and 255. The entry method is the same method as the IP
address.
11 Press the [OK] key.
IMPORTANT
After changing the setting, restart the network from System Menu, or turn the
machine OFF and then ON.
Restart Network (page 7-9)
NOTE
The network can be configured from the PC by using Command Center RX. Refer to the
Command Center RX User Guide.
21
IPv4 Setting:
Auto-IP
Exit
02
Subnet Mask
04
IP Address
03
Subnet Mask:
0. 0. 0. 0
21
IPv4 Setting:
IP Address
Exit
03
Subnet Mask
04
Default Gateway
05
Default Gateway:
0. 0. 0. 0