Operation Manual

Stater button
To starter the engine, press the starter button,
with the ignition switch ON ( ) and the engine
stop switch at RUN ( )

Headlight switch
Turning the switch to the " " position to
switch off the headlight.
Turning the switch to the " " position to switch
on the low beam.
Turning the switch to the " " position to switch
on the high beam.
The headlight switch should be operated when
you add the headlight equipment (using genuine
KYMCO accessories).
．
．
The USA model does not come equipped with
headlights as standard equipment.
If the headlight is not equipped, be sure to turn
the headlight switch " " to prevent battery
discharge.
See starting instructions prior to starting
engine (see page 42 for details).
CAUTION:
If the starter switch is pushed with the ignition
switch " " and the engine stop switch " ", the
starter motor will be activated but the engine
will not start. To start the engine, be sure to
position the engine stop switch at " ".
．
NOTE:
NOTE:
22