User Guide

ManualsBrandsKymco ManualsOtherMO MXer

17. LIGHTS/ SWITCHES

17-0

MX’er SYSTEM

__________________________________________________________________________________

________ ________________ ________________ ________________ ________________ __________

LIGHTS/SWITCHES

________ ________________ ________________ ________________ ________________ __________

SERVICE INFORMATION -------------------------------------------- 17- 2

TROUBLESHOOTING ------------------------------------------------- 17- 2

HEADLIGHT ------------------------------------------------------------ 17- 3

INSTRUMENTS/STOP LIGHT/TAILLIGHT------------------------ 17- 4

IGNITION SWITCH ---------------------------------------------------- 17- 5

STOP SWITCH ---------------------------------------------------------- 17- 5

STARTER BUTTON---------------------------------------------------- 17- 6

HEADLIGHT SWITCH------------------------------------------------- 17- 6

ENGINE STOP SWITCH----------------------------------------------- 17- 6

Summary of content (7 pages)

PAGE 1
7.
PAGE 2
17.
PAGE 3
17. LIGHTS/ SWITCHES MX’er SYSTEM SERVICE INFORMATION GENERAL INSTRUCTIONS • An electric tester is needed to measure or test the electric equipment. • Be sure to use fuses and bulbs of the same specifications to avoid damage of electrical equipment. • After installation of each switch, a continuity check must be performed. A continuity check can usually be made without removing the part from the motorcycle.
PAGE 4
17. LIGHTS/ SWITCHES HEADLIGHT BULB REPLACEMENT Disconnect the cover of the ignition switch and remove the two headlight attaching bolts. Remove the headlight and disconnect the headlight wire coupler. MX’er SYSTEM Cover Bolts Remove the two headlight case attaching screws and disconnect the headlight. Screws Check the bulb for damage and replace with a new one if necessary. Disconnect the headlight wire coupler. Remove the rubber boot. Push and disconnect the spring from the headlight cover.
PAGE 5
17. LIGHTS/ SWITCHES Remove the headlight bulb MX’er SYSTEM Headlight Bulb INSTALLATION Install the headlight in the reverse order of removal. ＊ After installation, adjust the headlight beam. INSTRUMENTS Light Shell Bulb Socket REMOVAL Remove the two headlight attaching bolts. Remove the headlight and disconnect the headlight wire coupler. Remove the two headlight case attaching screws and disconnect the headlight. Remove the light shell, rubber boot and bulb socket.
PAGE 6
17. LIGHTS/ SWITCHES Remove the bulb and check the bulb for damage. Replace with a new one if necessary. IGNITION SWITCH Check for continuity between the wires indicated below. Color Position Black Red OFF ON ○ Black/ White ○ Green ○ ○ STOP SWITCH Disconnect the front stop switch wire coupler. Check for continuity between the front stop switch wires. Brake lever applied: There is continuity. Brake lever released: There is no continuity.
PAGE 7
17. LIGHTS/ SWITCHES MX’er SYSTEM Yellow/Brown STARTER BUTTON Yellow/ Red Remove the center cover. Disconnect the starter button yellow/brown and yellow/red wires. Check for continuity between the black and yellow/red wires. Color Position Yellow/Brown FREE PUSH Yellow/Red ○ ○ Starter Button White Black Brown HEADLIGHT SWITCH Remove the center cover. Disconnect the headlight switch wire coupler. Check for continuity between the headlight switch wires.