User Guide

18. ONLY ATV ON ROAD AVAILABLE

18-0

MX’er SYSTEM

__________________________________________________________________________________

________ ________________ ________________ ________________ ________________ __________

ONLY ATV ON ROAD AVAILABLE

________ ________________ ________________ ________________ ________________ __________

WARING DIAGRAM --------------------------------------------------- 18- 1

BRAKE PEDAL ADJUSTMENT -------------------------------------- 18- 2

INSTRUMENT ---------------------------------------------------------- 18- 3

INDICATOR LIGHT---------------------------------------------------- 18- 3

HAZARD SWITCH ----------------------------------------------------- 18- 4

HORN--------------------------------------------------------------------- 18- 4

PAGE 1
8.
PAGE 2
18.
PAGE 3
18. ONLY ATV ON ROAD AVAILABLE BRAKE PEDAL ADJUSTMENT MX’er SYSTEM Brake Pedal The brake pedal free play should be adjusted to 10~20 mm (0.4~0.8 in) at the brake pedal pivot. If the free play is incorrect, adjust as Follows: 10~20mm Keep front brake lever free play at 10~20 mm (0.4~0.8 in). (Refer to page 3-9) Loosen the lock nut. Turn the adjusting bolt until the front lower brake cable is tensed.
PAGE 4
18. ONLY ATV ON ROAD AVAILABLE MX’er SYSTEM INSTRUMENT REMOVAL Remove the two instrument attaching screws. Disconnect the instrument. Screws Battery Cover Remove battery cover on instrument back to replace battery. ＊ After replace battery, the instrument will be reset. (Refer to owner’s manual) Speed Wheel SENSOR WHEEL If the sensor is lost or wore, the speed will be not calculated on the instrument. Screw INDICATOR LIGHT REMOVAL Remove the screw and disconnect the cover of the ignition switch.
PAGE 5
18. ONLY ATV ON ROAD AVAILABLE Remove the bulb socket and bulb. Check the bulb for damage and replace with a new one if necessary. MX’er SYSTEM Bulb Socket INSTALLATION The installation sequence is the reverse of removal. Bulb HAZARD SWITCH Check for continuity between the wires indicated below. Color Position Yellow/ Black Black ○ ○ ● Hazard Switch HORN REMOVAL Disconnect the horn switch wire. Remove the bolt and remove horn. INSTALLATION The installation sequence is the reverse of removal.