Operation Manual

(4) BATTERY

X This model adopts the battery which needs no refilling

of distilled water.

X When cleaning the terminal terminals, remove the

screws attaching the battery cover on the floor board and

then open the battery cover.

X When battery terminals are corroded, take out the

battery for cleaning.

X After cleaning, apply a thin coat of grease or Vaseline to

battery terminals and then install the battery.

※CAUTION:

X Never open the closed-type battery electrolyte cap.

X If the motorcycle will not be used for a long time, the

battery will discharge electricity by itself. Remove the

battery and put it in a cool place after it is fully charged

to prevent electricity leakage.

X If the motorcycle will not be used for a long time,

remove the negative (-) terminal.

X Do not smoke or allow flames or sparks near the battery

while removing and installing it.

X Turn off the ignition switch before removal or

installation. The negative (-) terminal shall be removed

first and the positive (+) terminal shall be installed first

X Tighten the loose terminal nuts securely.