Operation Manual

36
(8)BRAKE FLUID LEVEL INSPECTION/REFILLING
· Remove the two screws from the brake fluid tank
and take off the cover.
· Add recommended brake fluid DOT-4 into the tank
until the fluid level reaches the upper limit
and then put on the cover and tighten the
screws.
· Recommended Brake Fluid:DOT-4
CAUTION:
· Do not mix brake fluid of different brands.It may
cause brake failure and is very dangerous.When
refilling brake fluid, use towels to cover and
protect the painted and coated
surfaces.(Replace at 10000km or every year.)
(9)RUBBER COVER INSPECTION FOR WIRE AND CABLE
· The cable cores are protected by the rubber
cover outside the connector.Check the rubber
cover frequently for proper installation.
· When washing the motorcycle,do not flush the
rubber cover directly or brush it.Use a wet rag
to wipe off dirt and dust.
① Rubber Cover ② Check Points