Operation Manual

32
(4)BATTERY
·The battery fluid level should be kept
within the upper and lower level lines.When
the fluid level nears the lower level
line,refill with distilled water to the
upper level line.
·When cleaning the terminal terminals,remove
the screws attaching the battery cover on
the seat and then open the battery cover.
·When battery terminals are corroded,take
out the battery for cleaning. After
cleaning,apply a thin coat of grease or
Vaseline to battery terminals and then
install the battery.
CAUTION:
·
If the motorcycle will not be used for a long
time,the battery will discharge electricity by
itself. Remove the battery and put it in a cool
place after it is fully charged to prevent
electricity leakage.
·A clogged or kinked breather tube will increase
the battery inside pressure and result in cracks.
·The battery fluid will overflow to corrode the
motorcycle if too much distilled water is filled.
·Turn off the ignition switch before removal or
installation.The negative(-)terminal shall be
removed first and thepositive(+)terminal shall
be installed first.
·Tighten the loose terminal nuts securely.