User's Manual

Important: When you use this product for the first time, the mouse may seem to be

sluggish because it takes between 12 to 16 hours of use for the batteries to be

recharged to obtain full performance. The other alternative is to recharge the

batteries before you use the Wireless optical mouse mouse device. Please remove

the batteries if you do not use this device for at least two weeks.

Warning: (Troubleshooting)

1. Please do not use Wireless optical mouse on a desk which is made of glass, mir

ror, iron, or black velvet. Also, a flat surface is necessary or the Optical Sensor

will error easily. When you use Wireless optical mouse on a desk that is made of

metal, try using a pad and reduce the receiving distance

2. Before the first installation is completed (channel setting ready), the mouse will

not work.

3. The Wireless optical mouse channel provides 256 ID-codes, and it automatically

selects the ID # for your mouse. You can only set up one Wireless optical

mouse at a time. But if you have additional Wireless optical mouse sets in an

area of 10 square meters, more interference will occur between the receiver and

your mouse.

4. If you feel the mouse does not move as smooth as usual, then the batteries have

lost their charge, so you need to replace them or use the USB battery charger Y

cable to recharge the batteries. The LED on the mouse shows the

battery-recharging status: it will shine when empty and be clear when the

batteries are recharged. You should set up the channel every time you replace

the batteries.

5. If you need to buy new batteries, please choose Ni-MH (Nickel-Metal-Hydride)

AA batteries, 1300 to 1500 mAH, 1.2 V. Please do not mix or use other types

of batteries (Li-ion, Ni-Cd, Alkaline, etc.). Recycle your batteries according

to local law.

6. The Wireless optical mouse with radio frequency gives you free movement and

an enjoyable experience. For optimal performance, place the receiver at least 8

inches (about 20 cm) away from the mouse and other electrical devices, such as

the computer, monitor, and etc.

Software Installation

1. Make sure the mouse is connected to the computer.

2. Put the Setup disk (or CD) into the disk drive.

3. Follow the instructions on the screen to finish the software installation.