User's Manual

4. If you feel the mouse does not move smooth as usual, then the batteries have lost

their charge, so please replace them. Also, the wireless icon will be blinking

“red” when there is a battery-low situation. The LED on the receiver shows the

battery-recharging status (from shining to LED completely “on” for battery full).

You should set up the channel every time you replace the batteries.

5. If you need to buy new batteries, please choose Ni-MH (Nickel-Metal-Hydride)

AA batteries, 1.2V, 1300 to 1600 mAH. Please do not mix or use other types

of batteries (Li-ion, Ni-Cd, Alkaline, etc.)

6. The Wireless optical mouse with radio frequency gives you free movement and

an enjoyable experience. For optimal performance, place the receiver at least 8

inches (about 20 cm) away from the mouse and other electrical devices, such as

the computer, monitor, and etc.

Software Installation

1. Make sure the mouse is connected to the computer.

2. Put the Setup disk (or CD) into the disk drive.

3. Follow the instructions on the screen to finish the software installation.

Factory Setting