User's Manual

ManualsBrandsKYE Systems ManualsElectronicsSLIMSTAR 800

ENGLISH

Hardware Installation

1. Install two AAA batteries into the keyboard.

2. Plug in your USB receiver to a USB port of your PC.

Replace Batteries

If the keyboard does not work properly, then the batteries have

lost their charge, so you need to replace them.

Warning: do not mix or use different types of batteries at the

same time.

ID Channel Setting and connection:

Follow these steps:

1. The micro dongle plug it into a USB port and wait about 5-10

seconds.

2. Press the connect button on the keyboard.

3. The connection will be executed and the kit will be ready for

use.

Summary of content (4 pages)

PAGE 1
ENGLISH Hardware Installation 1. Install two AAA batteries into the keyboard. 2. Plug in your USB receiver to a USB port of your PC. Replace Batteries If the keyboard does not work properly, then the batteries have lost their charge, so you need to replace them. Warning: do not mix or use different types of batteries at the same time. ID Channel Setting and connection: Follow these steps: 1. The micro dongle plug it into a USB port and wait about 5-10 seconds. 2. Press the connect button on the keyboard.
PAGE 2
ENGLISH “Warning (Trouble shooting) 1. In case the wireless device was not connected when you set the ID channel setting, check if you have installed the batteries with the positive (+) and negative (-) polarity in the correct position, then repeat the ID channel setting again. 2. For optimum performance, please make sure that the distance between the wireless device and the micro dongle receiver does not exceed 10M.
PAGE 3
ENGLISH Notes on Battery Usage When you use the battery, carefully read and strictly observe the Safety Instructions and the notes described below: Different battery types and surrounding temperatures may affect the battery performance. Avoid using batteries in extremely cold environments as low temperatures can shorten the battery life and reduce wireless device performance.
PAGE 4
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.