User's Manual

How to install
1. Turn OFF the PlayStation
®
2 console.
2. Insert batteries into the coreless analog controller paying attention to the plus and
minus ends as indicated in the battery compartment.
3. Insert the receiver unit connector securely into the controller port (Console port 1
and Port 2) located on the front panel of the PlayStation
®
2 console.
4. Turn ONPlayStation
®
2 console.
5. When using it for the first time, press and hold the button on the receiver unit for
two seconds and release till the receiver unit LED lights up in ORANGE.
6. Press the POWER button on the cordless analog controller. The mode indicator
LED located on the cordless analog controller will light up in ORANGE and start
connecting with receiver unit.
7. After the cordless analog controller connects to the receiver unit, the receiver unit
indicator LED will turn to GREEN from ORANGE and the mode indicator of the
cordless analog controller will go off (the mode indicator indicates the mode status
at present).
8. Once the connection is completed, you can use the controller right away without
setting it again. Please repeat the above steps if the connection fails or there is
any interruption that occurred during operation.
Before using the cordless analog controller, rotate the analog sticks once with your
thumbs as shown in the diagram above. Please make sure all steps are properly
followed.