Installation Instructions

ManualsBrandskwikSTIK ManualsBuilding materialsPhillips 10' P1 Super Wide Paper-Faced Metal Corner Bead

kwikSTIK

Paper Faced Metal Drywall Beads & Trims

The information and recommendations contained herein are, to the best of Phillips Manufacturing Company’s knowledge and belief, accurate and reliable as of the date issued. Phillips Manufacturing Company has no

control over the conditions of handling and use, and makes no warranty regarding the results obtained from the use of this da ta. The information and recommendations are offered for the user’s consideration and

examination, and it is the user’s responsibility to determine that they are suitable and complete for its particular use. Phillips reserves the right to make alterations and amendments to the detailed specifications at its

discretion. Phillips disclaims responsibility for all actions, proceedings, liabilities, claims, damages, cost, losses, and expenses in relation to, or arising out of, incorrect utilization of this information.

Version 1.1 / Page 1 of 2

Installation Recommendations

Tape-On Paper Faced Beads & Trims Installation

1. Select or cut kwikSTIK

bead or trim to appropriate length. Vertical wall beads should be 3/8" to 1/2" shorter than the

wall to provide adequate floor clearance. Intersecting corners may be cut square to fit over purchased corner caps or

base transitions.

2. Apply all purpose joint compound by one of the following methods. Lightweight topping-only compounds are not

recommended for the first layer. All purpose and vinyl-based compounds produce the strongest corners.

a) With a narrow taping knife, apply an approximately 1/16" thick layer of joint compound to the drywall corner,

extending approximately 2" wide from the corner;

b) For fast and economical installation, use a commercially available tape-on hopper applicator. Set up hopper

applicator per manufacturer's instructions for the particular bead or trim style(s) to be installed. Fill hopper with

all purpose joint compound. Run the kwikSTIK

bead or trim through the hopper applicator to apply an even

distribution of joint compound to the wall side of the kwikSTIK

bead or trim;

c) With a commercially available mechanical applicator, apply an even distribution of all purpose joint compound to

the wall corner. Follow applicator manufacturer's instructions.

3. Press the kwikSTIK

bead or trim to the corner and into the joint compound layer. For best appearance slide the bead

or trim close into the ceiling (or the most visible corner). Check to make sure the bead is properly centered on the

corner (the straight edge of a taping knife can be used to gauge the bead distance from each wall line). Stroke along

the paper leg(s) with a narrow taping knife held at about a 45˚ angle to embed and remove any air bubbles under the

paper. A corner roller tool designed for this purpose may also be used to press the bead into the embedding layer.

Some drywall installers prefer to apply pressure by hand, wearing waterproof gloves.

4. Remove excess joint compound. Let dry.

5. With a medium width taping knife, apply a second coat of joint compound on top of the kwikSTIK

paper faced legs.

This coat should be carefully feathered 1" to 3" past the first layer. Again remove excess compound. Sand lightly as

needed after drying.

6. With a wide taping or finishing knife apply a topping coat of joint compound, feathered 1" to 3" past the previous coat.

When this coat has thoroughly dried, sand smooth and paint.

Nail-On Bead Installation

Phillips kwikSTIK

Nail-On Paper Faced Beads is used where mechanical fastening is desired. Install using staples,

screws or nails. Finishing is then completed as described for regular corner bead.

Made in the U.S.A.

Phillips is proud that all our beads, trims and accessories are made in the United States of America.