Deadbolt Installation

1x 3x
ball tip
3 / 4
Re-key the lock (if needed). Install the battery cover.
Conirm that the code(s) added in step 6 can unlock the door.
A B
Checkmark symbol with one beep
Option 1
Touch screen with
palm or back of
hand until digits
illuminate.
Option 2
Touch lower left
area of screen
(where checkmark
is located) until
digits illuminate.
Option 3
Touch screen
with three or
more ingers until
digits illuminate.
“X” pattern with three beeps
or
IMPORTANT:
Remove battery
pack before
re-keying.
Make sure the door is
open. Press the Program
button once.
Activating the Screen Locking the Door Unlocking the Door SecureScreen™
Press checkmark
symbol once.
Enter user code. A total
of 16 user codes may
be programmed.
Press lock symbol once.
A B C D
Did you see the checkmark symbol illuminate with one beep* or see the “X” pattern lash with three beeps*?
E
Programming Timeout
During programming, if the screen is not pressed for 20 seconds, the system will time out (indicated
by three beeps and the “X” pattern lashing three times), and you will need to restart the procedure.
Programming was successful. Programming was unsuccessful.
Make sure the user code is not a duplicate and that it is between
4 and 8 digits during your next attempt.
Make sure the lock has room for an additional code. If all user code
positions are illed, delete a code to make room for this one.
1. Activate the screen.
2. Press Lock symbol.
Note: If no user codes are
programmed, the door cannot
be locked via touchscreen.
1. Activate the screen.
2. If SecureScreen™ is enabled, touch
the random digits that appear.
3. Enter user code.
If you press the wrong digit while entering
a user code, you can press the Lock symbol
once to clear the digits entered previously and
immediately restart the code entry process.
If desired, this feature
can be disabled by
turning switch #4 to
the o position. See
“Switches” on page 4.
SecureScreen is an added-security feature
that displays random digits before you enter
a user code to unlock the door. This feature
ensures that there are ingerprints on all
digits so that codes cannot be identiied by
examining the touchscreen for inger prints.
Each user code must
be a unique code
between 4 and 8 digits.
*Beeping sound will only be heard if switch #3 (on the lock interior) is in the on positon. See “Switches and Status LED Colors” on page 4.
Mastercode
For enhanced security, a mastercode may be used when adding and deleting user codes. For more information about the mastercode,
download the Programming and Troubleshooting Guide on the SmartCode 915 page at www.kwikset.com.
M
G
S (3x)
K
J
K
a a
b b
c
Re-key the lock
to work with your
existing key. See
the supplied
SmartKey Re-key
instructions for
more information.
Keep “G” in a safe place, as you will need it to access
the back panel for additional programming.
Reinstall
battery
pack.
6
7
8
Add user codes
Re-key the lock (if needed) and install the battery cover
Test the lock (review normal operation)