User's Guide
K60x User Guide
name, a browser page of that device is opened. By hovering over the signal quality graphic,
detailed signal level information is displayed. You can change SSID and unit Role
configuration by clicking on the tool icon in the section banner, assuming you are an
authorized user.
The LAN section displays the unit’s assigned IP address and the status of the three Gigabit
Ethernet ports. By hovering over the Ethernet port icons, detailed port status information is
displayed. The unit’s IP configuration can be changed by clicking on the tool icon in the
section banner. Clicking on the Ethernet port icons allows a user to enable and disable
ports as well as turn PoE output on or off for ports one and two.
The Device section displays and provides configuration capability for Device Location and
Device Description.
The LAN Peers section displays the names of all K60x units that are connected to the
current unit over a LAN connection. In most cases, these would be collocated units that
provide additional wireless connectivity from that location.
The Administration section displays the software and the hardware versions of the device
and includes controls to change user password, upgrade device software, flash device LEDs
for device identification, and to reboot the device.
11 Using the K60x Command Line Interface (CLI)
11.1 Requirements
The K60x CLI allows for direct configuration of both Hub and Remote units. To connect
using Command Line Interface from a Linux, Unix or MAC computer terminal window type
ssh kwikbit@KB-XX-XX-XX.local where KB-XX-XX-XX is the Host name of the unit that
appears on the label on the side of the unit. For example, if the unit Host name is
KB-C5-6B-78, then the command line is ssh kwikbit@KB-C5-6B-78.local. For the password
prompt enter kwikbit. You should receive a command prompt
11.2 K60x CLI commands
The K60x CLI provides device status as well as configuration options commands.
At the prompt type “?” for the list of commands and their operation.
12 System Provisioning
Network planning, installation procedure and commissioning are most efficiently
performed using the Kwikbit Edge Controller. In addition, the Edge Controller enables
Kwikbit K60x User Guide - 22 -