User's Guide
K60i User Guide
2. After successfully opening the WebUI page, the unit’s IP address can be changed by
clicking on the Wired Network section tool icon:
● When prompted for user name, enter root admin for the username and
kwikbit_root for password.
● Select the desired address assignment protocol. If static address is selected,
enter the network mask and default gateway.
● Click Submit and the unit will reboot with the new address assignment. Your
browser will automatically reconnect and display the page.
3. Click on the Wireless section tool icon to configure wireless communication
parameters:
● Select the role of the unit. When configuring a PTP or PMP communication
system, only one of the wirelessly connected devices may be configured with
a Hub role. The units connecting to the Hub wirelessly must be configured as
Remotes.
● Configure SSID, airlink passcode and channel frequency (not required on
remote). These parameters must match between the Hub and all wirelessly
connected Remotes in order to establish wireless communication.
● If a configured Remote can connect to multiple Hubs, you may want to set
the optimal Hub in the Preferred Hub field.
● There needs to be a Hub node configured with Network Root = enable.
Alternatively, each remote needs to be configured with “Preferred Hub”.
Lacking both of these will result in Remote nodes periodically scanning
attempting to locate the Root node.
● Click Submit to save changes.
4. Click on the tool icon in the Device section to configure the Location at which the
device will be physically installed and the description of the device. Click Submit.
5. In the Admin section, click on the second icon to change the management interface
password.
The unit is now configured and ready to be installed.
Kwikbit K60i User Guide
Confidential & Proprietary - 21 -