User's Guide
K60i User Guide
The Device section displays and provides configuration capability for Device Location and
Device Description.
The LAN Peers section displays the names of all K60i units that are connected to the
current unit over a LAN connection. In most cases, these would be collocated units that
provide additional wireless connectivity from that location.
The Administration section displays the software and the hardware versions of the device
and includes controls to change user password, upgrade device software, flash device LEDs
for device identification, and to reboot the device.
10 System Provisioning
Network planning, installation procedure and commissioning are most efficiently
performed using the Kwikbit Edge Controller. In addition, the Edge Controller enables
centralized network operation view and management. Please see the Kwikbit Edge
Controller User Guide for detailed information.
If it is desired to provision a K60i network without the use of edge controller, the following
tasks associated with preparing a K60i system must be followed:
1. Initial system setup and IP configurations
2. Setting units’ roles
3. Setting SSID and airlink connectivity passcode
4. Setting communication channel frequency
10.1 Initial System Setup and IP Configurations
All new K60i units shipped from the factory are identical with a default software
configuration loaded. You must connect to the management interface in order to configure
the following system management parameters:
1. Connect your computer directly to the unit with an Ethernet cable. Once connected,
open a browser on the computer and enter the following URL:
https://KB-XX-XX-XX.local where KB-XX-XX-XX is the Host name of the unit that appears
on the sticker on the back of the unit. If the unit Host name is KB-C5-6B-78, for
example, then the URL address of the unit is https://KB-C5-6B-78.local. Initially, the
browser will display a warning stating that the connection is not secure. You may
ignore the warning and proceed connecting to the unit. To avoid receiving the
browser warning, please visit the Kwikbit support site, download the Kwikbit security
certificate and install it on your browser.
Kwikbit K60i User Guide
Confidential & Proprietary - 20 -