User's Guide
K60 User Guide
more information on the Kwikbit Edge Controller device and associated applications, please
refer to the Kwikbit Edge Controller User Manual.
The K60 system provides the following network management functions:
1. Device configuration information and status is displayed on the WebUI page
interface as shown above in Figure 2. When the mouse cursor is hovered over an
Ethernet Port or wireless connections icon, detailed information is displayed. In the
Wireless section, the list of wirelessly connected devices is displayed. The list of LAN
connected devices is displayed in the LAN Peers section. The WebUI of a connected
device is established by clicking on the device’s name.
2. Configuration Management. The system configuration section covers several
functional areas:
● Device
o Device location
o Device description
● Wired Network
o Device IP address assignment
▪ Static address
▪ DHCP – requires DHCP server
▪ Automatic Zero Configuration address assignment
o Management VLAN
o Ethernet ports
▪ Enable / Disable
▪ PoE Enable / Disable (port 2 and 3)
● Wireless Network
o Device role
o SSID
o Airlink passcode
o Channel frequency
o Preferred Hub (if device configured as Remote)
3. Administration Operations:
● Flash LEDs of the device – used to identify location of physically installed device
● Change administrator password of the device
● Upgrade device software
● Reboot the device
To reset the device to factory defaults:
● Insert the Reset Dongle (available separately) into Ethernet Port 2
● Cycle the power
● During power-up, observe the LED.
● Remove the Reset Dongle when the LED pattern indicates that the reset has been
triggered (refer to the LED Indicator Codes section of this document)
● The device is now operating at factory default settings
Kwikbit K60 User Guide - 16 -