Operator's Manual

DISASSEMBLY

It is not recommended to disassemble the gun unless you have BBs jammed inside the

barrel or for maintenance purpose only.

1. Remove magazine by depressing magazine releases on either side of Airsoft

gun.

2. Check and clear the chamber of BBs.

3. Pull back the slide until small cut out slot on the slide aligns with the front end of

the slide stop.

4. While holding the slide in position, remove the slide stop by pushing on the

release pin on the right side of frame. Pull off the slide-stop from the left side of

the frame.

5. Glide the slide forward, away from the frame.

ASSEMBLY

1. Put the slide onto the frame rails. Glide it toward the rear of the Airsoft gun until

the small cut-out slot on the slide aligns with the slide stop hole.

2. While holding the slide in position, insert the slide-stop.

3. Pull the slide to the rear-most position and then release.

4. Install the magazine.

NOTE: After the slide assembly is completed, cycle the slide back and forth to insure

proper assembly.

Push Slide Stop

Release Pin

Align