Operator's Manual

CHARGING GAS
1. Release the magazine by pressing the magazine release button.
2. Push the gas canister nozzle into the charging valve. Make sure the canister is in
a vertical position when charging.
3. Charge the magazine until gas overows from the charging valve.
WARNING: Avoid dropping the magazine. Sudden impact with a
hard surface may cause damage to the magazine.
Note:
It is normal to have minor leaking from the charging valve during charging due to
high pressure built up inside the magazine. It is recommended to keep the gas release valve
slightly oiled. Room temperature is the ideal temperature for shooting. You may experience
a delayed action if the surrounding temperature drops below 68º F.
Note: Do not expose the magazine to direct sunlight or incinerate the magazine, as this
may cause the magazine to burst. It is strongly recommended to empty the gas from the
magazine after shooting. Be certain that the gas does not make contact with eyes or skin
while being released, as any contact will cause cold burns.
Green Gas safety tips:
• Check the canister for any cracks or leaks before using.
• Do not expose the canister to temperature over 104º F.
• Do not leave the canister directly over re.
• Do not heat the canister.
• Keep the canister away from direct sunlight.
• Do not leave the canister in any type of vehicle.
!
Charging
Valve
Magazine
Release
Nozzle
Magazine
1
2
3
11
1911 MARK PTP SERIES