Operator's Manual

DISASSEMBLY

Note: Before opening the receiver, the piston must be in the forward position.

1. Shoot in semi-automatic mode 2-3 times to clear the barrel and reset the piston.

2. Remove the Rear Pin only from lower receiver with the provided Allen wrenches.

3. Use 1 wrench to hold the cap screw and one to turn the set pin.

4. After removal of the cap screw, use the allen wrench to push the pin out.

5. Pull the Upper receiver up.

6. Slide out the inner barrel with Hop-Up assembly.

ASSEMBLY

1. Insert the inner barrel and Hop-Up assembly into the upper receiver.

2. Secure the Hop-Up assembly into the upper receiver. Push down the upper

receiver to close.

3. Align the pin holes. Insert Pin and use the allen wrench to tighten the cap screw.

WARNING: Before removing any parts, be sure the re selector

is set to “SAFE”. Always place safety cap on the barrel tip

when servicing your gun.

Retaining Pin

Cap

Screw