Operator's Manual

WARNING: Before removing any parts, be sure the re selector

is set to “safe”. Always place safety cap on the barrel tip when

servicing the gun.

DISASSEMBLY

Note: Before opening the receiver, the piston must be in the forward position.

ASSEMBLY

1. Insert the inner barrel and Hop-Up

assembly into the upper receiver

2. Secure the Hop-Up assembly into

the upper receiver. Push down the

upper receiver to close

3. Align the pin holes. Insert the Pin

and use the allen wrench to tighten

the cap screw

1. Fire in semi-automatic mode 2-3 times to clear the barrel and reset the piston.

2. Remove the Rear Pin only from lower receiver with the provided Allen wrenches.

3. Use one wrench to hold the cap screw and one to turn the set pin.

4. After removal of the cap screw, use the allen wrench to push the pin out.

5. Pull the Upper receiver up.

6. Slide out the inner barrel with Hop-Up assembly.

If the receiver does not open, repeat step 1 as necessary.

Retaining Pin

Cap

Screw

KM4 SR7