Operator's Manual

BASIC TROUBLESHOOTING GUIDE FOR RIFLES
SYMPTOMS POSSIBLE CAUSE SOLUTIONS
Airsoft gun is not fi ring
Selector set to Safe Mode
Select Semi-Auto or Full-auto
Mode
Motor damaged or bad
connection
Return gun for professional care
Pinched wiring
Return gun for professional care
Motor or battery is hot after use
Pinched wiring
Return gun for professional care
Motor damaged or bad
connection
Return gun for professional care
Semi-Auto feature not
functioning
Incorrect timing
Dry fi re on Full-Auto
High pitch or grinding noise
Gear may be damaged/ Motor
level not adjusted
Return gun for professional care
BB double feeding/rolling out
of barrel
Hop-Up unit is contaminated
Clean Hop-Up unit with cleaning
rod
Hop-Up unit may be damaged
Return gun for professional care
Inner barrel is jammed
Use of low quality/recycled BBs
Use KWA Perfect BBs or other
high quality BBs
Inner barrel is contaminated
Clean inner barrel with cleaning
rod
Inner barrel is damaged
Return gun for professional care
OPERATING UNDER UNUSUAL CONDITIONS
Unusual conditions are defi ned as any condition requiring special maintenance.
Perform maintenance outlined for the climate similar to your operational area.
Extreme Cold:
Operating an Airsoft gas gun in extremely cold temperatures is not recommended. Cold
temperatures will cause the Hop-up Bucking to harden, reducing its eff ectiveness. Gas will not
expand properly in cold temperatures, so both the cycling rate and power will be dramatically
reduced.
Extreme Heat:
Operating an Airsoft gas gun in extremely hot temperatures is also not recommended. Leaving
the gun in direct sunlight for long periods of time, or operating in extremely hot areas will cause
the gas to over-expand, damaging the internal workings of the gun. The increase in internal
pressure from the expanding gas can also damage the seals and cause leaks in the magazine.
Dust or Sand:
Dust or sand can get into a gas gun and cause malfunctions and/or excessive wear. Keep
the gun covered whenever possible. Use lubricant sparingly, as lube naturally attracts dirt
and other particles. After use in a dusty area, always fi eld strip the gun (refer to Disassembly
Section) and clean any areas you can reach with a soft, lint-free cloth.
19