Operator's Manual

CLEANING

The Airsoft gun inner barrel should be cleaned after each shooting session. Regular cleaning

prevents damage that can be caused by excess oil, dirt, BB residue, and debris buildup.

Cleaning Procedure

1. Ensure that the safety is engaged.

2. Remove the magazine and clear the chamber of loaded BBs.

3. Disable Hop-Up by dialing to the OFF Position (see Hop-Up Section on page 15).

4. Disassemble the receiver (see Disassembly section on page 17).

5. Steps to use cleaning rod:

a. Cut a piece of clean cotton cloth to 1 inch by 0.5 inch size. Insert one end of the

cloth into the hole in the cleaning rod (adjust the length of cloth for smooth entry

into the barrel).

b. Wind the cloth around the cleaning rod.

c. Insert the cleaning rod into the inner barrel, and push the rod through.

d. Remove the cleaning rod and check the cotton cloth for dirt. Repeat steps 5a-5c

when necessary.

WARNING:

- Unload and clear the Aisoft gun before cleaning.

- DO NOT use spray silicone oil as a cleaning solution for the inner barrel.

Cleaning Rod

Cotton

Cloth

KM4 KR SERIES