Operator's Manual

DISASSEMBLY

1. Remove magazine.

2. Shoot in semi-automatic mode 2-3 times to clear the barrel and reset the piston.

Note: Check and clear the chamber of BB’s.

3. Set the selector to SAFE.

4. Remove the rear pin only from the lower receiver with the provided Allen wrenches.

5. Use 1 wrench to hold the cap screw and one to turn the set pin.

6. After removal of the cap screw, use the allen wrench to push the pin out.

7. Pull the upper receiver up.

8. Slide out the inner barrel with Hop-Up assembly.

WARNING:

- Always place the safety cap on the barrel tip when servicing your gun. Be

sure the ﬁ re selector is set to “SAFE”.

- If the receiver does not open, repeat step 2 as necessary.

ASSEMBLY

1. Insert the inner barrel and Hop-Up

assembly into the upper receiver.

2. Secure the Hop-Up assembly into

the upper receiver. Push down the

upper receiver to close.

3. Align the pin holes. Insert the

pin and use the allen wrench to

tighten the cap screw.

Retaining

Cap

Screw