Operator's Manual

BATTERY INSTALLATION

1. Set ﬁ re selector to safe mode. Place the safety cap on the barrel end. Gently pull the

butt plate release tabs to remove the cover.

2a. Two types of battery can be used, Nunchuck battery and small Li-Po pack battery.

When using a Nunchuck battery, place the battery into the stock. Push the connector

plugs together ﬁ rmly until they click into place.

2b. When using a small Li-Po pack battery, place the battery into the butt plate. Push the

connector plugs together ﬁ rmly until they click into place. *Make sure the small Li-Po

pack battery size is no larger than 4”H x 1.25”W x 0.62”D

3. Replace the butt plate by pressing it onto the stock until the retention tabs on the side

snap into place.

WARNING: Stock must be fully collapsed before opening the stock

cover. Do not remove the stock completely from the gun, doing so will

disconnect the terminal inside

Connector Plug

Small Lipo Pack Battery

Nunchuck

Battery

Pull on

Stock Cover

Release Tabs

Stock

Cover

FUSE

To replace the fuse, remove the butt stock cover and replace fuse with up to 20A glass fuse.

Fuse

Remove

Stock

Cover