Operator's Manual

19
ASSEMBLY
1. Place the recoil spring onto the bolt assembly.
2. Lock the bolt assembly onto the upper frame.
3. Install the upper frame onto the lower frame and align the bolt knob hole. Make
sure the hook underneath the bolt hooks onto the impact block
4. Push the bolt knob into the bolt assembly and push the slide assembly to the
rear.
5. Align the retaining pin holes.
6. Insert the 2pc retaining pins.
7. Cycle the bolt to assure proper reassembly before shooting.
S
S
2
3
4
6
1
Retaining Pin
Retaining Pin
M11A1 NS2
Recoil
Spring
Bolt Assembly
Upper Frame
Lower Frame
Bolt Knob