Operator's Manual

DISASSEMBLY
It is not recommended to disassemble the gun
unless for general maintenance, or to clear
BBs jammed inside the barrel.
1. Remove the magazine by depressing
the magazine release.
2. Remove the stock from the receiver
(see pg13).
3. Pull the bolt handle to lock the bolt.
4. Check and clear the chamber from
any BBs.
5. Using your nger tip, or small pen
like tool, press down on the retaining
pin 1, from within retaining pin 2, and
pull it out from opposite end.
6. Pull retaining pin 2 out from the
receiver. The pin is seated tightly in
the receiver, considerable effort may
be needed to pull it out.
7. Pull the upper frame upward and
forward until it stops on bolt handle.
(continue on next page)
17
SAFE FIRE
3
6
5
2
7
Retaining
Pin 1
Pull Bolt Backward
Pull Up and
Forward
Remove Stock
Retaining
Pin 2
M11A1 NS2