Operator's Manual
14
OPERATING UNDER UNUSUAL CONDITIONS
Perform maintenance outlined for the climate similar to your operational area.
Extreme Cold:
also do not expand as well in cold temperatures, so cycling rate and power will both be
dramatically reduced.
Extreme Heat:
Operating an Airsoft gas gun in extremely hot temperatures is not recommended. Leav-
ing the gun in direct sun light for long periods of time or operating in extremely hot areas
will cause the gas to expand, damaging the internal workings of the gun. The increase in
internal pressure from the expanding gas can also damage the seals and cause leaks in
Dust or Sand:
the gun covered whenever possible. Use lubricant sparingly, as lube naturally attracts dirt
-
BASIC TROUBLESHOOTING GUIDE
SYMPTOMS POSSIBLE CAUSE SOLUTIONS
Slide jams / Will not complete cycle Dry internal
Add silicone to cylinder / main
seal/ rails
Double feeds BB’s into chamber / BB’s
roll out of barrel
Hop-up adjustment too tight Release hop-up or replace bucking
BB’s will not release from magazine /
bent mag lip/ check bb condition
Bended magazine lip
Replace magazine lip
Leaking release valve & charging valve Dry O-ring Add silicone oil to valves
Safety lever not working Loose screw on lever Tighten lever allen screw
Slide will not disassemble Broken locking block Send in for repair service
Slide stop engages while shooting BB’s Weak slide stop spring Adjust tension
Magazine base plate will not lock Broken base plate lock Replace base plate lock
Magazine base leaking air Worn out base seal Replace magazine base seal
Cylinder will not load BB’s into chamber Broken Cylinder tap Replace cylinder
Trigger will not reset
Worn out trigger spring / trigger bar
spring
Replace trigger spring / trigger bar
spring