Operator's Manual

BATTERY INSTALLATION
1. Set the re selector switch to safe mode then remove hand guard retaining pin.
2. Slide hand guard off.
3. Turn gun over and place battery into compartment, back end rst, then plug
battery into connector.
4. Place hand guard back on the gun. Align retaining pin holes and push the
retaining pin back into the gun. Make sure to push the retaining pin all the way
in until click securily into place.
FUSE
To replace the fuse, remove the hand guard
and replace the fuse with a 20A glass fuse.
Fuse
Retaining Pin
Hand Guard
Battery
Connector Plug
1
2
3
9
H&K G36C