Operation Manual

TracVision M9 User’s Guide
59
Appendix B - Programming User-defined Satellites
6a. (Linear systems only) - Repeat Step 5 for each
polarization/band:
6b. (Circular systems only) - Repeat Step 5 for each
polarization/band:
If your selected satellite does not have information for
one or more of these transponder categories, you can
enter the following defaults instead:
7. Type
ZAP then press Enter. The antenna restarts. Wait
one minute for system startup.
8. Refer to “Setting the MCU to Track Satellites” on
page 19 to select your new user-defined satellite(s) for
tracking from the satellite library. Be sure use the
following installation names for your user-defined
satellite(s):
•Vertical High
•Vertical Low
•Horizontal High
•Horizontal Low
•Right • Left
Transponder Data Default Value
Frequency 00000
Symbol rate 27500
FEC code Same value as other transponders
with valid data
Network ID 0x0000
Satellite Installation Name
User-defined Satellite 1 USER1
User-defined Satellite 2 USER2