Operation Manual

TracVision M9 User’s Guide

Appendix B - Programming User-defined Satellites

3. Type the following SATCONFIG command then press

Enter:

SATCONFIG,X,A,B,C,D

4. Type

@DEBUGON then press Enter.

5. Type the following

@SATCONFIG command then

press Enter:

@SATCONFIG,X,E,F,G,H,I,J,K

Field Description

X User-defined satellite stored in antenna library

(User1 = User-defined Satellite 1 or

User2 = User-defined Satellite 2)

A Longitude (0-180)

B E (East) or W (West)

C Decoding type (2 = DSS, 3 = DVB)

D Polarization (L = linear) (C = circular)

Field Description

X User-defined satellite stored in antenna library

(User1 = User-defined Satellite 1 or

User2 = User-defined Satellite 2)

D Satellite table # (98 = User1; 99 = User2)

E Frequency, MHz (00000 or 10700-12700)

F Symbol rate, kilosymbols per second (10000-45000)

G FEC code (12, 23, 34, 56, 67, or 78)

H Network ID, hexadecimal (0x####)

I Polarization (V = vertical; H = horizontal;

R = right; L = left)

J LNB down conversion frequency

(U = USA [11250 MHz];

L = low [9750 MHz];

H = high [10600 MHz];

G = Latin America [10500 MHz];

S = Sinosat [11300 MHz])

K Decoding type (2 = DSS, 3 = DVB)