Operation Manual

TracVision M9 User’s Guide
26
Chapter 3 - Settings
Configuring Satellite Settings
If a satellite’s parameters are changed to use different parameters than
those stored in the TracVision system, you can use the flowchart in
Figure 3-3 to configure one of the satellites selected for tracking.
TIP: Circular satellites use the following polarization/band combinations:
right (RHC) and left (LHC). Linear satellites use the following polarization/
band combinations: vertical high (VH), vertical low (VL), horizontal high
(HH), and horizontal low (HL).
TIP: You can find satellite information on the web at www.lyngsat.com (this
website is not affiliated with KVH).
Figure 3-3 Configuring Satellite Settings
Sat B Menu Sat C
Tracking Satellite A
Yes Next Return
Install Satellite?
Yes Next Return
Operations Mode?
Yes Next Return
Get Antenna Status?
Yes Next Return
Control Antenna?
Yes Next Return
Man Control Antenna?
Yes Next Return
Configure Satellite?
Sat A Sat B Sat C
Configure Satellite
Yes Next Return
Configure Satname1?
Select “ Next ”
until “Configure
Satellite?” is
displayed.
Select which
satellite to
configure.
Select “Next”
until “Operations
Mode?” is
displayed.
– Enter +
Set Freq: XXXXXMHz
Yes Next Cancel
Configure Frequency?
– Enter +
Sym Rate: XXXXXM/S
Yes Next Cancel
Configure Symbol Rate?
– Enter +
FEC Code: X/X
Yes Next Cancel
Configure FEC Code?
– Enter +
Set ID: XXXXXXXXHEX
Yes Next Cancel
Configure Network ID?
– Enter +
Polarization: XXX
Select “ – ” or “+”
to change the
value of each
parameter. Then
select “Enter.”