Operation Manual

TracVision M9 User’s Guide
12
Chapter 2 - Operation
Turning the System On/Off
Since power to the antenna is controlled by the MCU, you can turn the
antenna on or off by applying/removing power to the MCU.
Turning On the System
Follow the steps below to turn on your TracVision system.
1. Make sure the antenna has a clear view of the sky.
2. Turn on your satellite TV receiver and TV.
3. Apply operating power to the MCU
TIP: When operating power is applied to the MCU, the MCU initiates a
startup sequence. The screen updates as diagnostic tests are performed.
4. Wait one minute for system startup. The MCU will
display the Tracking Satellite screen after system
testing is complete.
Figure 2-3 Tracking Satellite Screen
Turning Off the System
Follow the steps below to turn off your TracVision system.
1. Remove operating power from the MCU.
2. Turn off your satellite TV receiver and TV.
Avoid turning the vessel or changing channels for one minute
after turning on the system.
IMPORTANT!
Sat B Menu Sat C
Tracking Satellite A