Installation Instructions

Appendix
27
Linear Sky Mexico Version Only
Use the wiring diagram in Figure 52 if you wish
to connect up to eight receivers to the TracVision
M9 system.
NOTE: You can purchase a Terk BMS-58 active
multiswitch, shown in Figure 52, from KVH (order
part #19-0573).
Be sure all receivers are grounded. If the
receiver has a 2-prong power plug, run a
ground wire from the receiver’s chassis to a
suitable ground point. If a potential exists
between AC and DC grounds, connect the
wire to the MCU’s DC return instead.
IMPORTANT!
Continued Connecting Additional Receivers
B
Figure 52 Wiring Diagram - Linear Sky Mexico Version
Receiver #8
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB
ETHERNET
L
Pr Pb Y
Satellite In
Receiver #7
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB
ETHERNET
L
Pr Pb Y
Satellite In
Receiver #6
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB
ETHERNET
L
Pr Pb Y
Satellite In
Receiver #4
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB
ETHERNET
L
Pr Pb Y
Satellite In
Receiver #5
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB
ETHERNET
L
Pr Pb Y
Satellite In
Receiver #3
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB
ETHERNET
L
Pr Pb Y
Satellite In
Receiver #2
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB
ETHERNET
L
Pr Pb Y
Satellite In
Receiver #1
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB
ETHERNET
L
Pr Pb Y
Satellite In
MCU
OUTPUT TO
ANTENNA
MAINTENANCE PORT RF PORT
POWER IN
+24 VDC
Vessel Power
Power In
Output to
Antenna
Antenna
Data/
Power
RF1 RF2
Multiswitch
Power
Supply
Sat A
18V
Sat A
13V
Sat B
13V
Sat B
18V
Rx1
Rx8Rx2
Rx7Rx3
Rx6Rx4
Rx5
22 KHz Tone