Installation Instructions

Appendix
26
Linear Quad Version Only
Use the wiring diagram in Figure 51 if you wish
to connect up to eight receivers to the TracVision
M9 system.
NOTE: You can purchase a Terk BMS-58 active
multiswitch, shown in Figure 51, from KVH (order
part #19-0573).
Be sure all receivers are grounded. If the
receiver has a 2-prong power plug, run a
ground wire from the receiver’s chassis to a
suitable ground point. If a potential exists
between AC and DC grounds, connect the
wire to the MCU’s DC return instead.
IMPORTANT!
Continued Connecting Additional Receivers
B
Figure 51 Antenna Wiring - Antenna with Linear Quad LNB
MCU
OUTPUT TO
ANTENNA
MAINTENANCE PORT RF PORT
POWER IN
+24 VDC
Vessel Power
Power In
Output to
Antenna
Antenna
Data/
Power
RF3 RF4RF1 RF2
Receiver #8
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB
ETHERNET
L
Pr Pb Y
Satellite In
Receiver #7
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB
ETHERNET
L
Pr Pb Y
Satellite In
Receiver #6
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB
ETHERNET
L
Pr Pb Y
Satellite In
Receiver #4
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB
ETHERNET
L
Pr Pb Y
Satellite In
Receiver #5
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB
ETHERNET
L
Pr Pb Y
Satellite In
Receiver #3
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB
ETHERNET
L
Pr Pb Y
Satellite In
Receiver #2
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB
ETHERNET
L
Pr Pb Y
Satellite In
Receiver #1
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB
ETHERNET
L
Pr Pb Y
Satellite In
Multiswitch
Power
Supply
Sat A
18V
Sat A
13V
Sat B
13V
Sat B
18V
Not Used
Rx1
Rx8Rx2
Rx7Rx3
Rx6Rx4
Rx5
22 KHz Tone