Operation Manual
TracVision M5/M7 User’s Guide
72
Appendix A - Advanced Settings and Functions
Configuring Satellite Settings
Use the flowchart in Figure A-3 to configure one of the satellites
selected for tracking.
TIP: Linear satellites use the following polarization/band combinations:
vertical high, vertical low, horizontal high, and horizontal low. Circular
satellites use the following polarization/band combinations: right and left.
Figure A-3 Configuring Satellite Settings
<Default Display>
Menu
Control Antenna?
Yes Next Return
Configure Satellite?
Yes Next Return
Select Next until “Configure
Satellite?” is displayed.
Man Control Antenna?
Yes Next Return
Install Satellite?
Yes Next Return
Configure <Sat Name>?
Yes Next Return
Configure Satellite
Sat A Sat B Sat C
Polarization: ###
- Enter +
Select - or + as required,
then select Enter (valid
polarizations are LHC,
RHC, HH, HL, VH, and VL).
Set freq: #####MHz
- Enter +
Select - or + as required, then
select Enter (valid range is
10700 - 12750 MHz, or 00000).
Sym Rate: #####M/S
- Enter +
Select - or + as required, then
select Enter (valid range is
01000 - 45000 kilosymbols
per second).
Set FEC Code: #/#
- Enter +
Select - or + as required, then
select Enter (valid codes are
1/2, 2/3, 3/4, 5/6, 6/7, 7/8).
Set ID: ######HEX
- Enter +
Select - or + as required, then
select Enter (valid range is
0X0000 - 0XFFFF hex).
Configure frequency?
Yes Next Cancel
Configure FEC Code?
Yes Next Cancel
Configure Network ID?
Yes Next Cancel
Configure symbol rate?
Yes Next Cancel
Get Antenna Status?
Yes Next Return
Operations Mode?
Yes Next Return
Select Next until “Operations
Mode?” is displayed.