Operation Manual

TracVision M5/M7 User’s Guide

Appendix A - Advanced Settings and Functions

5. Use the flowchart in Figure A-2 to scan the frequency

data of the selected satellites.

TIP: If you know the satellite configuration data, you can configure the

satellite without scanning frequency data (see “Configuring Satellite

Settings” on page 72).

TIP: Scanning satellite frequencies might take up to 10 minutes.

Figure A-2 Scanning Frequency Data

Operations Mode?

Yes Next Return

Select Next until “Operations

Mode?” is displayed.

Control Antenna?

Yes Next Return

Sat frequency Scan?

Yes Next Return

Select Next until “Sat

Frequency Scan?” is displayed.

Man Control Antenna?

Yes Next Return

Install Satellite?

Yes Next Return

Symbol Rate: XXXXX

- Enter +

Select - or + as required,

then select Enter (valid range

is 01000 - 39999 kilosymbols

per second).

Set FEC Code: X/X

- Enter +

Select - or + as required,

then select Enter (valid codes

are 1/2, 2/3, 3/4, 5/6, 6/7, and

7/8).

Updating frequency

Please wait

Restart antenna?

Yes No

Get Antenna Status?

Yes Next Return