Operation Manual

TracVision M5/M7 User’s Guide
51
Chapter 3 - Settings
Step 1 - Configure the Satellites
Use the flowchart in Figure 3-25 to configure the TracVision system for
linear Dual-Sat Mode.
NOTE: Be sure to record the skew angle (the average skew for both satellites)
reported during this procedure. You will need this information to adjust the
TracVision system’s skew angle.
Figure 3-25 Configuring Linear Dual-Sat Mode
<Default Display>
Menu
Install Satellite?
Yes Next Return
Circular or Linear?
Cir Lin Cancel
Trisat Mode?
Yes No Cancel
Install Satellite?
Yes Next Return
Install <SAT NAME>
Yes Next Cancel
Install <SAT NAME>
Yes Next Cancel
Press Next until your choice
for Satellite A is displayed,
then press Yes.
Press Next until your choice
for Satellite B is displayed, then
press Yes. (Choose “NONE” as
your choice for Satellite B if you
wish to install just one satellite.)
Set Lat/Long?
Yes Next Cancel
Set Sat Switch Type
Auto Manual Cancel
IMPORTANT: Choose Auto for
setups without a multiswitch installed;
choose Manual for setups with a
multiswitch installed.
Press - or + to toggle each
digit to the desired value, then
press Enter to accept each digit.
Latitude: ##N
- Enter +
Longitude: ###E
- Enter +
Press - or + to toggle each
digit to the desired value, then
press Enter to accept each digit.
Record the skew angle for
later use, then press OK.
Latitude: ##N
Longitude: ###E
Skew Angle ##.#
OK
Restarting Antenna
<SAT A>, and
<SAT B> installed