Operation Manual

TracVision M5/M7 User’s Guide
49
Chapter 3 - Settings
Figure 3-23 Configuring European Tri-Sat Mode
Step 2 - Adjust the LNB Skew Angle
Now that you have installed the desired Tri-Sat group and recorded
the skew angle for the Tri-Sat group, you need to adjust the antenna’s
LNB skew angle to optimize signal reception. Follow the instructions
in “Adjusting the Skew Angle (Linear Versions)” on page 31 to adjust
the skew angle.
<Default Display>
Menu
Install Satellite?
Yes Next Return
Circular or Linear?
Cir Lin Cancel
Trisat Mode?
Yes No Cancel
Install Satellite?
Yes Next Return
Install Europe WB?
Yes Next Cancel
Install Europe?
Yes Next Cancel
Install Scandinavia?
Yes Next Cancel
Press Next until your desired
Trisat Group is displayed, then
press Yes.
Press - or + to toggle each
digit to the desired value, then
press Enter to accept each digit.
Press - or + to toggle each
digit to the desired value, then
press Enter to accept each digit.
Record the skew angle for
later use, then press OK.
Latitude: ##N
- Enter +
Set Lat/Long?
Yes Next Cancel
Longitude: ###E
- Enter +
Latitude: ##N
Longitude: ###E
Skew Angle ##.#
OK
Restarting Antenna
Set Sat Switch Type
Auto Manual Cancel
IMPORTANT: Choose Auto if you
don’t have a multiswitch installed;
choose Manual if you do have a
multiswitch installed.
<SAT A>, <SAT B>,
and <SAT C> installed