Operation Manual

TracVision M5/M7 User’s Guide
47
Chapter 3 - Settings
Use the flowchart in Figure 3-21 to configure the TracVision system for
your custom pair of satellites (or single satellite).
Figure 3-21 Configuring Custom Dual-Sat Mode
<Default Display>
Menu
Install Satellite?
Yes Next Return
Circular or Linear?
Cir Lin Cancel
Service= DIRECTV?
Yes Next Cancel
Service= Custom?
Yes Next Cancel
Install Satellite?
Yes Next Return
Press Next until
Service= Custom? is displayed.
Install <SAT NAME>
Yes Next Cancel
Install <SAT NAME>
Yes Next Cancel
Press Next until your choice
for Satellite A is displayed,
then press Yes.
<SAT A> and
<SAT B> installed
Restarting Antenna
Press Next until your choice
for Satellite B is displayed, then
press Yes. (Choose “NONE” as
your choice for Satellite B if you
wish to install just one satellite.)
Manual Switching Only
Set Lat/Long?
Yes Next Return
Press - or + to toggle each
digit to the desired value, then
press Enter to accept each digit.
Press - or + to toggle each
digit to the desired value, then
press Enter to accept each digit.
Latitude: ##N
- Enter +
Longitude: ###E
- Enter +