Operation Manual
TracVision M5/M7 User’s Guide
36
Chapter 3 - Settings
Setting Instant On
When Instant On is enabled, the antenna can immediately receive
signals if the vessel has not moved since the antenna was last shut off.
However, if the system is turned off, and then the vessel moves after
last acquiring the satellite via Instant On, the antenna will undergo its
standard initialization process once it is turned back on. This results in
a brief delay.
NOTE: Instant On is disabled by default and is not recommended for DISH
Network and ExpressVu configurations.
Use the flowchart in Figure 3-9 if you wish to enable Instant On, or if
you wish to restore the original setting.
Figure 3-9 Enabling/Disabling Instant On
Operations Mode?
Yes Next Return
Get Antenna Status?
Yes Next Return
Control Antenna?
Yes Next Return
Set instant on/off?
Yes Next Return
instant mode: ON
On Enter Off
Select On or Off as required,
then select Enter.
Select Next until “Operations
Mode?” is displayed.
Select Next until “Set instant
on/off?” is displayed.
<Default Display>
Menu
Install Satellite?
Yes Next Return