Installation Instructions

30
To connect three or more receivers to a system
configured for Sky Mexico, follow these steps to
install a Spaun model SMS 5602 NF multiswitch
(KVH part #19-0413) between the grounding
block and the receivers, as shown in Figure 47.
1. Connect an RF cable from the “RF1”
connector on the grounding block to the
“H/High” (Horizontal High) connector on
the multiswitch.
2. Connect an RF cable from the “RF2”
connector on the grounding block to the
“V/High” (Vertical High) connector on the
multiswitch.
3. Set the multiswitch’s LNB knob to “22 KHz.”
At this setting, the multiswitch will provide a
constant 22 KHz tone to the antenna’s LNB.
4. Connect the receivers to the individual
outputs of the multiswitch.
5. Connect the receivers to the customer’sTVs.
SATELLITE IN
OUT TO TV
TV ANT/CABLE IN
AUDIO VIDEO S-VIDEO PHONE JACK
RL
Satellite In
SATELLITE IN
OUT TO TV
TV ANT/CABLE IN
AUDIO VIDEO S-VIDEO PHONE JACK
RL
Satellite In
SATELLITE IN
OUT TO TV
TV ANT/CABLE IN
AUDIO VIDEO S-VIDEO PHONE JACK
RL
Satellite In
SATELLITE IN
OUT TO TV
TV ANT/CABLE IN
AUDIO VIDEO S-VIDEO PHONE JACK
RL
Receiver #3
Receiver #2
Receiver #1
Receiver #4
Satellite In
RF2 RF1
Grounding
Block
Vessel
AC Ground
Ground Wire
RF2 RF1
AC Power In
100-240 VAC
50-60 Hz
H/High
V/HighH/Low
V/Low
LNB
22 KHz
18V
12V
432
1
5
6
Receivers
Terr
Multiswitch
Figure 47: Multiswitch Wiring - Sky Mexico
Wiring 3+ Receivers
A
Sky Mexico Systems