Operation Manual

TracVision M3/M2 User’s Guide

Appendix C - Programming User-Defined Satellites

4. Type the following @SATCONFIG command then

press Enter:

@SATCONFIG,X,E,F,G,H,I,J,K

5. Repeat Step 4 for each polarization/band:

If your selected satellite does not have information for

one or more of these transponder categories, you can

enter the following default values instead:

6. Type @DEBUGOFF then press Enter.

7. Type ZAP then press Enter. The antenna restarts. Wait

one minute for system startup.

8. Follow the steps in “Selecting Satellites to Track” on

page 27 to select your new USER A or USER B satellite.

Field Description

X User-defined satellite stored in antenna library

(996W = User A; 997W = User B)

E Frequency, MHz (00000 or 10700-12700)

F Symbol rate, kilosymbols per second (10000-45000)

G FEC code (12, 23, 34, 56, 67, or 78)

H Network ID, hexadecimal (0x####)

I Polarization (V = vertical; H = horizontal)

J LNB down conversion frequency

(L = low; H = high; G = Latin America; S = Sinosat)

K Decoding type (1 = DSS-A; 2 = DSS-B; 3 = DVB)

• Vertical High

•Vertical Low

• Horizontal High

• Horizontal Low

Transponder Data Default Value

Frequency 00000

Symbol rate 27500

FEC code Same value as other transponders

with valid data

Network ID 0x0000